[caldera_form id=”CF5bd8960ce7833″]
[caldera_form id=”CF5bdc5e6d26ec8″]
The AdAPTor3000-Series Automatic Paralleling Switchgear is a low cost solution used to connect two generators in parallel.
AdAPTor3000-Series Automatic Paralleling Switchgear Features:
Upon receipt of an automatic start signal initiated locally by the operator or remotely by customer’s ATS or SCADA or DCS (via closure of a dry contact or optional Modbus interface), the control panel shall issue a start signal to both generator sets. If the bus is dead and other conditions are appropriate, the first generator to build up voltage and frequency shall close its circuit breaker, energizing the bus. The second genset shall be automatically synchronized with the load bus under the supervision of the dedicated synchronizing check relay. When all the synchronizing conditions are met the generator circuit breaker shall close. At this time, transfer switch inhibit logic will allow the ATS to transfer to generator power.
Upon receipt of an automatic stop signal initiated locally by the operator or remotely by customer’s ATS or SCADA or DCS system the switchgear shall automatically open the circuit breakers and remove the genset start signals, allowing shutdown of the gensets after their EMCP3 programmed cool down period.
Synchronizing lights, synchronizing check relay, circuit breaker control switch and speed adjust potentiometer are available for Manual-Permissive synchronizing.
Engine-Generator set with engine control module (Caterpillar ADEM, EMCP or similar), load sharing module or load sharing governor and generator voltage regulator capable of voltage droop operation.
Notifications
